M2 2M-1K2 Instruções de Operação

3/1/12 Rev.01 PLEASE READ BEFORE USE AND SAVE TROUBLESHOOTING OVERVIEW INSTALLATION ADDENDUM WARRANTY M2 Antenna Systems, Inc. Model No: 2M-1K2 2

10 TROUBLESHOOTING TROUBLESHOOTING SUPPORT, SERVICE AND RETURNS If you have followed the provided troubleshooting steps and your product is still no

11 TROUBLESHOOTING TROUBLESHOOTING

12

13

14 ADDENDUM ADDENDUM DESCRIPTION...QTY 2M-1K2 2M High Power Amplifier...

15 Model ...2M-1K2 Frequency Range...144-148 MHz Power Out...1

16 ADDENDUM ADDENDUM WSJT: What Is It and How Do I Get It? WSJT is a new weak signal mode enhancing communications with signal near or below the audi

17 ADDENDUM ADDENDUM One last bit of information you will need to get started using EME. Since most signals from the moon are at or below the noise

18 12 MONTH LIMITED WARRANTY This warranty gives you specific legal rights. You may also have other rights which will vary from state to state or pro

19

2 CONTENTS SECTION...PAGE COVER PAGE ...

3 OVERVIEW OVERVIEW It is with great satisfaction that M2 now offers a true breakthrough in high power VHF amplifiers. Our goal has always been to o

4 OVERVIEW MAJOR COMPONENTS, 2M-1K2 1 2 3 4 5 6 7 8 FRONT PANEL 1. +50V LED (Yellow). Indicates +50 VDC is present from the power supply 2.

5 OVERVIEW REAR PANEL (shown with optional power supply) 9. Key Jack. Ground to transmit. The total keying current is under 10 mA. 10. RF In. 25

6 The 2M-1K2 designation, indicates the amp works on the 2 meter Amateur Band and is capable of at least 1.25 kW of RF output. A single MRFE6VP61K2

7 voltage also passes through the transformer. The emitter of the device is grounded to its flange base (header) which in turn is attached to the co

8 INSTALLATION INSTALLATION Transceiver ANT KEY OUT TYPICAL INSTALLATION INSTALLATION CONSIDERATIONS • WARNING: SAFETY IS ALWAYS A PRIORITY! ALW

9 Problem Possible Cause Solution No +50 V LED (Yellow) when the ON/OFF switch is actuated. AC voltage to power supply is below 185 VAC. Verify that